HP XP Continuous Access Software - Manual (Page 269)

Troubleshooting RAID Manager 269
HORCM_009 CA/RM connection to
RM failed. System devices are
improperly connected, or an
error exists in the RM
configuration file
$HORCM_CONF
.
See the RM startup log to
identify the cause of the
error.
HORCM_101 CA/RM and RM
communication failed. A system I/O error occurred
or an error exists in the RM
configuration file
$HORCM_CONF
.
See the RM startup log to
identify the cause of the
error.
HORCM_102 The volume is suspended. The pairing status was
suspended.
Call the HP support center.
HORCM_103 A validation check error
was detected on the
volume. A validation error occurred
on the database volume or
validation parameters for
this volume are illegal. Confirm the following
items, and use the
raidvchkdsp -v <op>
command to verify the
validation parameters.
The Block size(-vs <size>)
is appropriate.
The type for checking (-vt
<type>) is appropriate.
Data validation is disabled
for LVM configuration
changes.
Data validation is not used
based on the File system.
The redo log and data file
are on separate volumes.
Error Code Problem Cause Solution