HP ESL E-series Tape Libraries - Manual (Page 62)

Viewing and editing the network settings (standalone libraries or primary cabinets only)
To view or edit the network settings:
1. From the Menu screen, use the Up and Down buttons to highlight Setup, then press Select.
2. The library prompts you for your password. Enter the 6-digit password and wait for validation.
The response may not be immediate.
NOTE:
The default password is 001122.
From the Setup screen, use the Up and Down buttons to select Change Network Settings and
press Select.
Figure 43 Network Settings
. 3. Use the Change Network screen to view and change as follows:
• Hostname—read only
• IPv4 Status—enable or disable
• IPv4 Address—view or edit
• Gateway—view or edit
• DHCP—enable or disable
• IPv6 Status—enable or disable
• Save Network Settings Now
NOTE:
You must enable at least one IP version. The system will fail to operate with both IPv4 and
IPv6 disabled.
Library operations 62