HP Surestore Disk Array 12h and FC60 - Manual (Page 379)

SureStore E Disk System SC10 Troubleshooting 379
T
roubl
esh
ooting
Note
It is normal for the amber Fault LED on a component to go on briefly when the
component initially starts up. However, if the Fault LED remains on for more
than a few seconds, a fault has been detected.
Interpreting Component Status Values (HP-UX Only)
Common status terms have specific indications for various disk enclosure components.
The component status condition terminology used by Array Manager 60 (AM60) may differ
from that used by STM. Both terms are identified in
Table 51 .
Table 51 Status Indications by Component
Component/Status Disks BCCs
Fans, Power
Supplies
Sensors
AM60: Good
STM: Optimal Component is installed and no error conditions are known.
AM60: Critical
STM: Fault - 2 N/A Hardware has failed. Voltage/temperature
exceeds critical limit.
AM60: Non-critical
STM: Fault - 3 N/A BCC A and B
have different
firmware
versions. N/A Voltage/temperature
exceeds warning limit.
AM60: Not Installed
STM: Not Present Component is not installed.
AM60: Unknown
STM: Fault - 0 N/A N/A N/A Sensor has failed or
status is not available.
Not Available Component is installed without known errors, but has not been turned on
or set into operation; or the controller that owns reporting has failed.