SkyTrak 8042 Service Manual User Manual
Page 312
6.7
Model 8042, 10042, 10054 Legacy
Rev. 10/03
Transmission: ZF 4 WG-98 TC
9. Place a suitable receptacle under the transmission
drain plug (5). Remove the transmission drain plug,
and allow the transmission oil to drain into the
receptacle.
10. Transfer the used transmission oil into a suitable,
covered container, and label the container as “Used
Oil.” Dispose of used oil at an approved recycling
facility. Clean and reinstall the transmission drain
plug.
11. Remove the engine-to-transmission drive shaft.
Refer to Section 5.4.3, b. “Engine-to-Transmission
Drive Shaft.”
12. Remove the transmission-to-axle drive shafts. Refer
to Section 5.4.3, a. “Transmission-to-Axle Drive
Shafts.”
13. Remove the hydraulic pump. Refer to Section 8.11.2,
14. Label and disconnect the transmission temperature
switch connector (6) and shift solenoid wiring
harness connectors (7 and 8).
15. Remove the capscrew (9) securing the black wire
(10) to the transmission housing, and disconnect the
wire. DO NOT reinstall the capscrew at this time.
16. Remove the capscrew (11) securing the clamp (12)
and wiring harness to the transmission housing, and
move the wiring harness safely out of the way. DO
NOT reinstall the capscrew at this time.
Figure 6- 1 Transmission Wiring
Harness Connector Location
17. Remove the capscrew (13) securing the lifting ring
(14) to the transmission housing. Once the lifting ring
has been removed, reinstall the capscrew into the
hole.
18. Move the lifting ring (14) to the holes (15) used to
secure the black wire (10) and clamp (12). Secure
the lifting ring using the capscrews (9 and 11), and
tighten securely.
OH2380
5
MH3390
6
7
8
9
10
11
12
MH3400
13
14
15