SkyTrak 8042 Service Manual - Manual (Page 482)

8.67 Model 8042, 10042, 10054 Legacy Rev. 10/03
Hydraulic System
8.9 FOUR-WHEEL STEER INDEXING
PROCEDURE
If the vehicle does not drive “straight,” the steering could
be out-of-phase. Perform the following indexing
procedures to synchronize the front and rear steering.
1. With the steer select switch in the four-wheel steer
position, turn the steering wheel full left.
2. While holding the steering wheel full left, toggle the
steer select switch to the front-wheel steer position,
and steer the front wheels back to center.
3. Toggle the steer select switch back to the four-wheel
steer position and turn the steering wheel full left.
4. Toggle the steer select switch back to the front-wheel
steer position, and steer the front wheels full left.
5. Toggle the switch to the four-wheel steer position,
and return to center.
The vehicle should now be properly indexed in four-wheel
steering. If the wheels are still out-of-phase, repeat the
above procedure. If, after repeating the above procedure,
the wheels are still out-of-phase, refer to Section 8.8.17,
“Four-Wheel Steering Circuit (Left Turn) and
Troubleshooting,” and Section 8.8.18, “Four-Wheel
Steering Circuit (Right Turn) and Troubleshooting.”