SkyTrak 8042 Service Manual - Manual (Page 618)

9.27 Model 8042, 10042, 10054 Legacy Rev. 10/03
Electrical System
7. When reassembling the right side console access
panel (3), torque the screws (4) to 3 - 5 lb-ft
(13 - 22 Nm).
8. If the vehicle has one battery, connect the
negative (-) battery cable to the negative (-) battery
terminal (1).
If the vehicle has dual batteries, connect both
negative battery cables to both negative (-) battery
terminals (2).
Testing Relays located in the Engine Compartment
1. Be sure the vehicle is on a level surface, the
implement grounded, parking brake engaged,
ignition switch is in the OFF position
2. Unlock and open the rear engine door.
3. If the vehicle has one battery, disconnect the
negative (-) battery cable at the negative (-) battery
terminal (1).
If the vehicle has dual batteries, disconnect both
negative battery cables from both negative (-) battery
terminals (2).
4. To remove the relays from inside the engine
compartment, label and remove all the wires
connected to the suspect relay.
To access the terminal nuts and washers on the grid
heater relays, lift the protective cover (10) and slide it
along the wire, away from the mounting hardware.
Save the terminal nuts and washers (11) for later
reassembly.
5. Remove the mounting hardware (12) from the
mounting bracket on the relay. Remove the relay
from the engine compartment.
6. Inspect the general condition of the relay casing and
terminals. Replace the relay if it is cracked or
damaged in any way.
MH4910
11
12
10
10