SkyTrak 8042 Service Manual - Manual (Page 738)

9.147 Model 8042, 10042, 10054 Legacy Rev. 10/03
Electrical System
With the ignition ON and
the lighting control lever
pushed up for left turn
signal or down for right
turn signal, turn signal
indicator and turn signals
remain OFF.
With hazard switch OFF,
check for battery voltage at
Pin 8, wire [1B] (RED) on
hazard switch.
Check for battery voltage at
Pin 1, wire [1B] (RED) on
hazard switch.
Check for battery voltage at
Pin 2, wire [33] (VIO) on
hazard switch.
Replace hazard switch.
Disconnect six position plug
at lighting control lever and
check for voltage at roadlight
harness Pin F, wire
[28A] (VIO).
Check for battery voltage at
Pin L, wire [28] (VIO)
on flasher.
Replace flasher.
Connect six position plug at
lighting control lever and try
turn signals.
Replace lighting control lever.
Check for battery voltage at
Pin X, wire [33] (VIO)
on flasher.
Before troubleshooting any
electrical circuit, ALWAYS
begin by checking the
following:
1. Fuses.
2. All connections relating
to circuit are clean and
tight.
3. Before troubleshooting
the turn signal circuit,
verify that the hazard
light circuit is operating.
If not, follow the steps
listed at, Section 9.7.49,
“Roadlights Hazard
Lights Circuit and
Troubleshooting
(Option),” before
troubleshooting the turn
signal circuit.
4. Before troubleshooting
the turn signal circuit,
verify that the worklight
circuit is operating. If
not, follow the steps
listed at, Section 9.7.53,
“Roadlights w/
Worklights Circuit and
Troubleshooting
(Option),” before
troubleshooting the turn
signal circuit.
5. If one of the turn signals
work, the circuit is fine,
the failed bulb needs to
be replaced.
If OK
Not
OK
Not
OK
Not
OK
Not
OK
Not
OK
Not
OK
Not
OK
If OK
If OK
If OK
If OK
If OK
Repair/replace roadlight
harness.
Repair/replace roadlight
harness.
Repair/replace roadlight
harness.
Repair/replace roadlight
harness.