ETC Cobalt Family v7.0.0 - Manual (Page 163)

161
• Subnet mask
o If DHCP is disabled, you set the Cobalt subnet mask here. This is a static setting
and will remain set until changed by a user.
o If DHCP is enabled, this field will display the subnet mask that is being used by the
console (whether it is served via DHCP or a self-generated link-local IP address).
• Gateway
o If DHCP is disabled, you set the Cobalt gateway IP address here. This is a static
gateway IP address and will remain set until changed by a user.
If DHCP is enabled, this field will display the gateway IP address that is being used
by the console (whether it is served via DHCP or a self-generated link-local IP
address).
• Physical Address - This is the address of the computer. On a typical ETC lighting network,
the default settings for IP address of the Ethernet connection for Cobalt is:
IP address: 10.101.84.101
Subnet Mask: 255.255.0.0
Default Gateway: 10.101.1.1
This addressing scheme should allow a Cobalt console to communicate with other ETC
equipment via Ethernet without requiring any changes to these settings. If more than one
Cobalt console of the same type are to be connected to the network, ensure that the default
addressing has been changed on consoles #2 and above.
Default IPs for all Cobalt family products
10.101.84.101 (Cobalt 20 console)
10.101.82.101 (Congo/Cobalt Light Server)
10.101.79.101 (Cobalt Nomad)
10.101.80.101 (Congo Console)
10.101.81.101 (Congo jr)
10.101.83.101 (Congo Kid)
Network - Output Protocols
This is where you activate different DMX-Over-Ethernet output protocols.