ETC Cobalt Family v7.0.0 - Manual (Page 589)

587
Device Control - Fan
The FAN key in the programming section is used to distribute values of a parameter evenly around a
centre point.
There are four shapes of fan:
Linear
S = S shaped
V = V shaped
U = U shaped
Function Key Feedback
1. Select channels Channel Select
functions Selected channels are
highlighted in the Channel
View
2. Select base channel* [NEXT] The focused channel is
highlighted in red
3. Fan parameter # [FAN] & [Wheel] Parameter # is fanned
according to the shape in
the Settings, around the
channel focused by
NEXT/LAST.
*If no base channel is selected, the centre channel of the selection is used.
Fan Settings
Hold SETUP and press FAN to open the Fan Settings