Danger – MacDon M150 SP User Manual

Page 206

Advertising
background image

MAINTENANCE AND SERVICING

Form 169017 / 169087 / 169095

204

Revision C

7.13.2 CASTER WHEELS

7.13.2.1 Tire

Inflation

a. Visually check daily that tires have not lost

pressure. Under-inflation of drive tires can cause
side wall cracks.

DANGER

To avoid severe personal injury or death
caused by machine runaway, shut off engine
and remove key before performing any of the
following checks and/or adjustments.

b. Measure tire pressure annually with a gauge.

Maintain the pressure at 10 psi (69 kPa).

NOTE

If caster wheels shimmy, a possible cause
is over-inflation.

DANGER

Never install a tube in a cracked wheel rim.
Never weld a wheel rim.
Make sure all the air is removed from a tire

before removing the tire from the rim.

Never use force on an inflated or partially

inflated tire. Make sure the tire is correctly
seated before inflating to operating
pressure.

Do not remove, install or make repairs to a

tire on a rim unless you have the proper
equipment and experience to perform the
job. Take the tire and rim to a qualified tire
repair shop.

If the tire is not in correct position on the

rim, or if too full of air, the tire bead can
loosen on one side, causing air to leak at
high speed and with great force. An air
leak of this nature can thrust the tire in any
direction, endangering anyone in the area.

Use a safety cage if available.
Do not stand over tire. Use a clip-on chuck

and extension hose.

Advertising
This manual is related to the following products: