MacDon M150 SP - Manual (Page 73)

WINDROWER OPERATION
Form 169017 / 169087 / 169095
71
Revision C
k. Make the electrical connections (J) at the header
wheel, and at the joint (K).
l. Attach weight box to windrower lift arm linkage as
follows:
IMPORTANT
To prevent damage to the lift system when
lowering header lift linkages without a
header or weight box attached to
windrower, ensure that float engagement
pin is installed in storage location (C), and
not installed at hole location (B).
1. Drive windrower so that windrower lift arms
are positioned into the weight box pockets.
2. Raise lift arms slightly and install locking pins
(D) into pockets and through windrower
header lift linkages. Secure with hairpin.
NOTE
Pins (D) were previously removed from the
header lift linkage lower end.
3. Route the weight box harness (O) to the
electrical connector at the left side lift linkage,
and connect harness to connector.
m. Raise lift arms, and move float pins from storage
location (C) to engaged position (B).
(continued next page)
D
C
B
B
C
J
K
O