Configure the rn10c devicenet scanner – Rockwell Automation 1752-L24BBBE SmartGuard 600 Controllers User Manual User Manual
Page 104
Advertising
104
Rockwell Automation Publication 1752-UM001E-EN-P - June 2014
Chapter 7
Configure Your Controller for DeviceNet Communication
4.
Verify that the 4 bytes of input data are mapped as shown.
5.
Right-click the PanelView Plus Interface in RSNetWorx software and
choose Download to Device.
Configure the RN10C DeviceNet Scanner
Follow this procedure to configure the RN10C DeviceNet scanner.
The shortcut in RSLinx Enterprise software should appear similar as shown.
Note that the slot number of the RN10C scanner is 2.
1.
Right-click the RN10C scanner and choose Properties.
2.
Enter the name of the scanner.
Advertising
This manual is related to the following products: