Rockwell Automation Logix5000 Logix5000 Controllers Quick Start - Manual (Page 61)

Publication 1756-QS001E-EN-P - October 2009 61
Program an Equipment Phase Chapter 4
Manually Step Through the States
Before you step through states, do the following:
• Download the project to the controller.
• Put the controller in run or remote run mode.
1. Right-click the equipment phase and choose Monitor Equipment Phase.
2. Click the Ownership and then Yes.
Use this window to step through the states.
3. Click Start.
The equipment phase goes to the Running state. Any code in the Running state routine starts running.
This is where you put the code for the normal production sequence of your equipment.