HP 2566C - Manual (Page 18)

(_ auiion f
Before moving the printer, make sure that the leveling feet are fully
raised. Roll the printer from the side to minimize the possibility of
tipping.
6. Move the printer.
Move the printer from the side to its new location. The printer is
more stable when rolled in this way.
At New Location
Note
1. Remove shipping brackets (if installed).
Refer to Figure 2-1 for locations.
2. Connect the power cord.
Connect the power cord to the AC power input jack on the back of
the printer and plug the other end into the AC outlet.
3. Lower the leveler feet.
Turn the printer’s leveling feet clockwise until all four wheels are just
off the floor. Next, level the printer.
For optimum performance of the powered paper stacker, make sure the
printer sits level on the floor. The output paper stack will not stack
correctly if the printer is not level.
4. Connect the interface cable.
Connect the interface cable from the computer system to the interface
connector on the back of the printer. If you have an HP-IB interface,
use the supplied shielded cable. Failure to use the appropriate cable
could cause electrostatic discharge (ESD) problems.
5. Load the ribbon and paper.
Follow the directions starting on page 3-5 to load the ribbon and
paper.
6. Switch the printer "ON."
Switch the main power ON/OFF (1/0) switch located on the back of
the printer to the “ON” (1) position.
7. Verify the configuration parameters.
Verify printer configuration as recorded in step 1 of “Moving the
Printer” on page 2-1.
GETTING THE MOST FROM YOUR PRINTER AND PAPER 2-3