HP 2566C User Manual
Page 38
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Adjusting Forms
Position
Use this procedure when you change the position of the form in the
printer, or want to set the horizontal paper tension. These insti-uctions
prepare your printer for the next step, “Adjusting Forms Thickness” on
page 3-21.
Notti
I
Too little or too much horizontal tension can cause paper jams in the
cp printer.
1. Adjust the left paper path.
With the swing-gate latched in the full open position, set the tractor
control knob to FORMS ALIGNMENT POSITION (Figure 3-19, A).
Press either of the tractor control keys (Figure 3-19, B) left or right
until the left tractors (Figure 3-19, C,D) are in the desired position
for printing the left page margin. Holding the center key down while
pressing the left or right key will increase the speed that the tractors
move.
Figure 3-19. '^ractor Conti ols
PREPARING THE PRINTER FOR OPERATION 3-17