HP 2566C User Manual
Page 37
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2. Preliminary adjustment of vertical paper tension.
Pull out the spring plunger knob again (Figure 3-18, A) and move the
lever downward until the paper is slightly taut against the platen.
(The platen is located in the curved black surface lying between the
upper and lower tractors.) To test the tension, place your hand on the
paper over the black surface and gently push the paper up and down
(Figure 3-18, B). If the paper moves freely, the vertical tension is too
loose. When the tension is correct, you will notice only slight vertical
looseness and no paper feed hole distortion.
3-16 PREPARING THE PRINTER FOR OPERATION