Pilz PNOZ s50 C - Manual (Page 33)

Commissioning
Operating Manual PNOZ s50
1002194­EN­02 33
NOTICE
Please note that all parameters are set to their default values on delivery.
Please check all the safety­related parameters at least, and enter the values
that correspond to your application.
6.2.3 Password protection
The configuration is password­protected.
} Parameters can only be changed once a password has been entered.
} Factory setting for the password: 000000
} The pasword consists of 6 figures in the range 000000 … 999999.
} The password can be changed at any time in the menu.
INFORMATION
– Please note: Remember the assigned password. Without this pass­
word you will not be able to change the configuration.
– For details of how to enter the password, see the section entitled
"Status display and configuration", Level 2: Entering the password.
– For details of how to change the password, see the section entitled
"Status display and configuration", Level 3: Configuration.
6.2.4 Use chip card
The parameters that are set on a device are stored on the chip card. The data is stored
along with a device identifier and check sum. We recommend that you always operate the
device with a chip card.
When the chip card is inside the device:
} The chip card is checked to verify the device identifier, valid parameters, and ensure
that the data is identical.
} Device parameters are automatically saved to the chip card during configuration. As a
result, the chip card always contains a copy of the device's current internal data.
When the device is switched on in the Power On operating state (all LEDs illuminate
briefly) a test is carried out to check whether
} a chip card is inserted or just an empty chip card holder
} data on the chip card matches the data in the device
} data on the chip card is valid.