KEYENCE AutoID - Manual (Page 96)

4-46
SETT
ING DEVICE OPER
A
T
IONS
4
4-8 RS-485 Master Unit (N-410) Settings
RS-485 Setting
The following describes the settings of the [RS-485 setting] tab for the N-410.
Item Description
Baud rate Select the baud rate (bit/s) from the pulldown menu.
Parity Select None, Even or Odd for Parity.
Data bits Select 7 bits or 8 bits for Data bits.
Stop bit Select 1 bit or 2 bits for Stop bit.
"Apply to all the slaves"
button Applies the parameters currently set on the N-410 to all of the NX-50RS's
that are currently connected to the N-410 that is being set up.
Slave direct command timeout Select 15 seconds or 60 seconds as the command timeout for slave devices.