2 setting macro operations, Setting macro operations, 2 setting macro operations -3 – KEYENCE AutoID User Manual
Page 99: Setting macro operations -3
OT
HER SETT
5
5-3
5-2
Setting Macro Operations
This section describes macro operation settings.
Setting Macro Operations
Item
Description
(1) Operation patterns
The operation settings of the currently set command are displayed.
Set operation on the [Act setting] tab.
(2) Result data
The destination for storing the result data of a read operation is displayed.
(3) Input data
The type of the source data in the operation is displayed.
(4) Continuous operation
settings
Set whether or not to execute the current macro operation continuously.
To continue the operation, select the "Cont" checkbox.
(5) Output destination
settings
Select from OK/NG/ERR as the result of macro operation, and set so that the
result is output to one of OUT1/OUT2/OUT3. Also, set serial output of the
operation result to
(enabled) or
(disabled).
(1) Operation patterns
(4) Continuous operation settings
(3) Input data
(2) Result data
(5) Output destination settings