Drylam Fujipla PLS3311 - Manual (Page 41)

AL-MEISTER PLS3311 INSTRUCTION MANUAL <Rev.3>
Press [START] key.
The blade moves to its ready position. Press [START] key again. The blade moves to the starting
point at the opposite side. Press [START] key again. The blade moves to its ready position. The
blade moves in this order by pressing the [START] key.
Adjust the ready position so that the blade is in the recommended position of 0.20~0.39” as
shown in the diagram. By moving the knobs to the left or right, the blade ready position can be
altered. NOTE ・Use the divisions at the blade position knobs to find out the right position.