Avery Dennison Monarch 9864 Error Messages - Manual (Page 35)

05/08 Rev. AB USER MANUAL Error Messages
9844 – 9854 – 9864
35
One of the following messages may appear next:
Status # Text
5020 I2C Timeout xx
5021 I2C Conf. xx
5022 I2C Busy xx
5023 I2C LAB xx
5024 I2C BER xx
5025 I2C Polling xx
Tab. 3 Messages to locate the I
2
C bus error. xx = ID of the concerned device
# Device 9864 9854
0 CPU X X
1 Feed motor X
2 Foil motor X
3 Printhead motor X
4 Peripheral motor X
5 Dispenser motor X
5 Rewinder motor
8 Rewinder (internal) X
12 USI board X
13 AI board
15 I/O board X
Tab. 4 Assignment of IDs in the status messages related to the I 2 C bus.
5001 No gap found
Status No gap found or several blank labels fed.
Action Press Online to acknowledge.
Check the print mask for gap definition (material length).
Make sure the correct material is loaded.
Make sure the photoelectric switch (sensor or punch sensor) is clean and
material is loaded correctly.
Check sensitivity of the photoelectric switch (Parameter
SYSTEM PARAMETERS > Sens. punch-LS ). Materials providing a poor contrast
between label and backing paper or between reflex mark and label require
a higher sensitivity setting.
Press Online to confirm and the material feeds forward automatically until
the next gap is found.