Avery Dennison Monarch 9864 Error Messages - Manual (Page 36)

05/08 Rev. AB USER MANUAL Error Messages
9844 – 9854 – 9864
36
5002 Material end
Status Material end. Material no longer in the gap LS.
Action 1. Press Online to acknowledge the status report.
Display: OFFLINE x JOBS
2. Load material and check the position of the photoelectric switch (punch
sensor). Adjust if necessary.
3. Press Online: processing of the job continues, gap is reinitialized.
5003 Cover open
Status 9864: Cover open
Cover is open. Opening the cover causes all other waiting messages to be
deleted while the "Cover open" message is displayed. Closing the cover
deletes the message.
9854: Printhead pressure lever open
The printhead pressure lever was opened, during:
• the feeding of material or
•
printing.
The error message is deleted when the printhead pressure lever is closed.
Action Close the cover or printhead lever.
5004 Rewinder mat. tear
Status Label material at the backing paper rewinder is torn off.
The 9854 Dispenser also displays this message if the backing paper sleeve
was too large during material initialization or the backing paper web could
not be tightened.
Action Press Online to acknowledge.
Secure label material to the rewinder.
5005 Knife-fault
Status Error at the cutter.
Action Press Online to acknowledge.
5006 Head-fault
Status Printhead lifting error (head sensor).
Action Check if dirt is preventing the printhhead contact lever from moving freely
and clean if necessary.
If not successful, call Service.