Gasboy CFN III Config Mnl V3.4 - Manual (Page 11)

MDE-4316C CFN Series CFN III Configuration Manual for Windows NT® · April 2007 Page 5
Introduction
FIX_CONF-D
You can also use the FIX_CONF command with the -D option to reset configuration
parameters to their default settings. The command looks like this:
FIX_CONF -Dconf_name [-Dconf_name [...]] filename
where conf_name is replaced either with:
• the name of the configuration parameter that is to be reset to defaults-such as READER,
PUMP, SYS_PAR* - or
• ALL for all configuration parameters at once.
ALL does not default to OFFROAD.
You may specify more than one parameter by repeating the -D option in front of the name of
each configuration parameter you want to reset to its default.
Replace filename with the name of your configuration file. If no file name is given, the
changes will be made to FRAMOS.CFG. When the site boots, it reads the FRAMOS.CFG file.
If you make changes under another file name, they will not take affect unless you copy your
file to FRAMOS.CFG.
ESC Key with NT
At this time, ESC only works with a few of the configuration programs. It is recommended
that you review the list below to check the functionality. While in configuration programs, the
ESC key usually opens the next line/parameter for modification/insertion. Since pressing ESC
is similar in effect to pressing CTRL-C, any text entered at the prompt before ESC is pressed is
ignored.
These configuration programs have these reactions to pressing ESC:
Pump: Does not work with this program.
Table: Next table is opened.
Perm: Next command is opened.
Reader: ESC signs you off if pressed at the first prompt. Once a menu selection is made, ESC takes
you to next parameter.
Gate: ESC signs you off if pressed at the first prompt. Once a menu selection is made, the next
Gate/Controller is opened for Gasboy only. ESC does not work with Unitec.
Console: Next entity (depending on the menu you are in) is opened for modification.
Fuelpt: ESC signs you off if pressed at the first prompt.