Select program sequence number, Set start time and operation mode, Operation (wall mounted controller only) (cont.) – MovinCool CM25 User Manual
Page 45
45
OPERATION
(Wall Mounted Controller ONLY) (cont.)
Select Program Sequence Number
1. Press and hold PROGRAM button for 3 seconds. “Pr
01” blinks.
Note: If any button is not pressed for 3 seconds,
program moves to the next step (selecting “Day of
the week”) automatically.
2. Press UP (
) or DOWN (
) button to scroll
program sequences.
3. Press ENTER button to select the program
sequence number.
Set Start Time and Operation Mode
4. “On” (program setting for unit ON) illuminates and
“Day of the week” blinks.
Press UP (
) or DOWN (
) button to select “Day
of the week”.
Press ENTER button. “Hour” blinks.
5. Press UP (
) or DOWN (
) button to select “hour”.
Press ENTER button. “Minutes” blinks.
Note: AM or PM changes with hour automatically.
6. Press UP (
) or DOWN (
) button to select
“minutes”.
Press ENTER button. “COOL” blinks.
7. Press UP (
) or DOWN (
) button to select mode “COOL” or “FAN ONLY”.
Press ENTER button. “RUN” blinks.
Note: Fan mode “RUN” is automatically set (no selection of “AUTO”) when
FAN ONLY is selected.
8. Press UP (
) or DOWN (
) button to select fan mode “RUN” or “AUTO”.
Press ENTER button. “HI” blinks.
9. Press UP (
) or DOWN (
) button to select fan speed “HI” or “LO”.
Press ENTER button. “Set temperature” blinks.
10. Press UP (
) or DOWN (
) button to select “Set temperature”.
Press ENTER button. “OF” (program setting for unit OFF) illuminates and
“Day of the week” blinks.
Note: To change the previous settings, press RESET button and start again
from “Day of the week” setting.