Welltech Dialogic SS7 Protocols ISUP - Manual (Page 115)

Dialogic ® SS7 Protocols ISUP Programmer's Manual Issue 15
115
Value Name Function
3 M-Unblock Maintenance unblock circuit(s)
4 M-Stop Abort maintenance (un)blocking
5 H-Block Hardware block circuit(s)
6 H-Unblock Hardware unblock circuit(s)
7 H-Stop Abort hardware (un)blocking
8 Query Initiate circuit group query
14 Set-Ic-Active Set state of circuit(s) to incoming active
15 Set-Og-Active Set state of circuit(s) to outgoing active
cic_mask
A 32 bit mask indicating to which of the circuits in the circuit group the
message applies. It is usual for a command to apply to all circuits in the
circuit group in which case cic_mask may be set to all ones.
7.3 Circuit Group Supervision Control Confirmation
This message is issued by ISUP to indicate successful completion of a circuit
group supervision control function.
Event Confirmation From ISUP
structure MSG
type ISP_MSG_CGSC_CONF (0x0709)
id gid
src ISUP module ID
dst Management module ID
rsp_req 0x00
hclass 0x00
status 0x00
err_info 0x00
len 6
offset 0, size 1 ptype Management primitive type.
offset 1, size 1 reserved Set to zero
parameters
offset 2, size 4: cic_mask Bits set to indicate affected circuits in
group.
Parameters
gid
The group identifier for the Circuit Group.