H3C Technologies H3C WX3000E Series Wireless Switches - Manual (Page 141)

128
Item Description
VLAN IDs
Set the IDs of the VLANs to/from which the selected ports are to be
assigned/removed. This item is available when the Untagged, Tagged, or Not A
Member option is selected in the Select membership type area.
IMPORTANT:
• You cannot configure an access port as an untagged member of a nonexistent
VLAN.
• When you configure an access port as a tagged member of a VLAN, or configure
a trunk port as an untagged member of multiple VLANs in bulk, the link type of the
port is automatically changed into hybrid.
• You can configure a hybrid port as a tagged or untagged member of a VLAN only
if the VLAN is an existing, static VLAN.
Link Type
Set the link type of the selected ports, which can be access, hybrid, or trunk.
This item is available when the Link Type option is selected in the Select membership
type area.
IMPORTANT:
To change the link type of a port from trunk to hybrid or vice versa, you must set the link
type to access first.
PVID Set the PVID of the select ports; selecting Delete is to restore the default PVID of the
ports to the default VLAN 1.
This item is available when the PVID option is selected in the Select membership type
area.
IMPORTANT:
The PVID of an access port must correspond to an existing VLAN.
Delete
VLAN configuration example
Network requirements
As shown in Figure 116 :
• Trunk port GigabitEthernet 1/0/1 of Switch A is connected to trunk port GigabitEthernet 1/0/1 of
Switch B.
• The default VLAN of GigabitEthernet 1/0/1 is VLAN 100.
• GigabitEthernet 1/0/1 permits packets of VLAN 2, VLAN 6 through VLAN 50, and VLAN 100 to
pass through.
Figure 116 Network diagram
Configuring Switch A
1. Configure GigabitEthernet 1/0/1 as a trunk port and configure VLAN 100 as its default VLAN:
a. Select Device > Port Management from the navigation tree.
b. Click the Setup tab.