Grass Valley PDR 200 Service Manual - Manual (Page 150)

Chapter 6 Parts Removal and Replacement
6-58 PDR 200 Service Manual
PAC208/216 Daughter Board
The Daughter Board attaches to stand-offs on the Main Board.
To remove the Daughter Board:
1. Perform the cover removal procedure (page 6-49).
2. Use the Torx tool with the T15 tip to remove the screws which secure the Daughter
Board to the stand-offs on the Main Board (Figure 6-36).
3. Carefully disconnect the Daughter Board from the connector on the Main Board and
lift up and out of the chassis.
To replace the Daughter Board:
1. Carefully connect the Daughter Board to the connector on the Main Board and align
the screw holes in the Daughter Board with the stand-offs on the Main Board
(Figure 6-36).
2. Use the Torx tool with the T15 tip to secure the Daughter Board to the stand-offs on
the Main Board with the screws previously removed.
3. Use the Torx tool with the T15 tip to secure the top cover with the screws previously
removed.
4. Replace the PAC208/216 in the rack.
5. Reconnect the power cord and turn PAC208/216 power On.