Grass Valley PDR 200 Service Manual - Manual (Page 74)

Chapter 4 Troubleshooting
4-24 PDR 200 Service Manual
Options - The Options menu consists of a single item - Preferences . Selection of this
item brings up the Preferences dialog box shown in Figure 4-6. This dialog box allows
you to select certain parameters which apply to all diagnostic tests when executed.
The box consists of a
Run panel and an On Error panel.
Figure 4-6. Preferences Dialog Box
The Run panel allows you to specify either how many times to run any selected test
from 0 (indefinitely) up to 99,999 times, or how long to run any selected test from 0
hours, 0 minutes (00:00) up to 99 hours, 59 minutes (99:59). Default is run 1 time. To
specify how many times or length of time mode, select the appropriate option on the
left.
The On Error panel allows you to specify what the program should do when a selected
diagnostic test fails. Modes and their descriptions are:
Stop - Cease executing any more tests at the completion of the test in progress.
This is the default setting.
Continue - Go on to the next test.
Loop - Execute the failed test the number of times entered in the box to the right.
The Loop value can be from 0 (indefinitely) to 99,999 times.
When satisfied, select OK to accept the parameters and close the Preferences dialog
box.
NOTE: Changes to these parameters are valid only during the current session.
Starting a new session sets the parameters to their default values.