Enterasys Networks 1G58x-09 - Manual (Page 401)

Policy Classification Configuration Command Set
Assigning Classification Rules to Policy Profiles
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide 8-9
Command Type
Switch command.
Command Mode
Read-Only.
Example
This example shows how to display policy classification information. In this case, there is a policy
classification entry number 1 assigned to profile index 1. It classifies Ethernet II (0x600) Type
frames to a Class of Service of 0. Currently, port fe.0.1 is active for this rule.
8.3.2.2 set policy classify
Use this command to assign incoming untagged frames to a specific policy profile and to VLAN or
Class-of-Service classification rules.
set policy classify profile-index classify-index {vlan | cos} classify-value {ether |
ipbil | ipdest | ipproto | ipsource | iptos | ipxbil | ipxbilsocket | ipxclass | ipxdest
| ipxdestsocket | ipxsource | ipxsourcesocket | ipxtype | llc | macbil | macdest |
macsource | tcpbilrange | tcpdestrange | tcpportdest | tcpportsource |
tcpsrcrange | udpportbil | udpportdest | udpportsource | udpsrcrange}
data_value [data_mask]
Matrix>show policy class
Policy Classification Entries
--------------------------------
Profile index: 1, Classification index: 1,
Priority: 0, Ethernet II Type: 600, Status: enabled,
Port List: None
----------
Port AdminID OperID
------- ------- ------
fe.0.1 1 0
fe.0.2 0 0
fe.0.3 0 0
fe.0.4 0 0
fe.0.5 0 0
fe.0.6 0 0
NOTE: Classification rules are automatically enabled when created.