10 set cep initialize, Set cep initialize -83, Section 11.2.6.10 – Enterasys Networks 1G58x-09 User Manual
Page 553: 10set cep initialize
Logging and Network Management Command Set
Configuring Convergence End Points (CEP) Phone Detection
Matrix E1 Series (1G58x-09 and 1H582-xx) Configuration Guide
11-83
Syntax Description
Command Defaults
None.
Command Type
Switch command.
Command Mode
Read-Write.
Example
This example shows how to set port 65 as the minimum port to be used for convergence end points
detection for CEP group 1
:
11.2.6.10set cep initialize
Use this command to re-initialize convergence end points detection on one or more CEP-enabled
ports.
set cep initialize port-string
detection-id
Specifies a CEP discovery group ID. This group must be
created and enabled using the set cep detection command
as described in
2147483647.
porthigh |
portlow port
Specifies a maximum or minimum UDP or TCP port to be
used for convergence end points detection.Valid values are
1 - 65535.
Matrix>set cep detection portlow 65