Yaskawa Z1000U - Manual (Page 233)

6.3 Connecting Peripheral Devices
Figure 6.1 illustrates how to configure the drive and motor to operate with various peripheral devices.
Refer to the specific manual for the devices shown below for more detailed installation instructions.
Copy Verify Read LOCK
Y ASKA W A
JVOP-181
USB Copy Unit COM
ERR
Power
Supply
Surge
Absorber
HOA Keypad
Engineering Software Tools
USB
Copy unit
Ground
Ground
Motor
Magnetic
Contactor
(switches to
line power)
USB Cable
(Type-AB)
USB Cable
(Type-AB, sold separately)
PC
Momentary
Power Loss
Recovery Unit
Line
Breaker
(MCCB)
or
Leakage
Breaker
Magnetic
Contactor
(MC)
Zero-phase
Reactor
Drive
U/T1 V/T2 W/T3 R/L1 n1 p1 S/L2 T/L3
DriveWizard
DriveWorksEZ
Figure 6.1 Connecting Peripheral Devices
Note: If the drive is set to trigger a fault output when the fault restart function is activated (L5-02 = 1), then a sequence to interrupt power when
a fault occurs will turn off the power to the drive while the drive attempts to restart. The default setting for L5-02 is 0 (fault output active
during restart).
6.3 Connecting Peripheral Devices
YASKAWA ELECTRIC TOEP C710636 10B Z1000U HVAC MATRIX Drive User Manual 233
6
Peripheral Devices & Options