RIGOL DG1000Z Series - Manual (Page 48)

RIGOL Chapter 2 Command System
2-36 DG1000Z Programming Guide
*TRG
Syntax *TRG
Description Trigger a sweep or burst.
Explanation  You can only trigger the sweep or burst via the remote interface when the
sweep or burst function is currently enabled and the trigger source is set to
manual (use the [:SOURce[<n>]]:SWEep:TRIGger:SOURce or
[:SOURce[<n>]]:BURSt:TRIGger:SOURce command).
 You can also send the [:SOURce[<n>]]:SWEep:TRIGger[:IMMediate] or
[:SOURce[<n>]]:BURSt:TRIGger[:IMMediate] command to trigger a sweep or
burst when the sweep or burst function is currently enabled and the trigger
source is set to manual.
Related
Commands
[:SOURce[<n>]]:BURSt:TRIGger[:IMMediate]
[:SOURce[<n>]]:BURSt:TRIGger:SOURce
[:SOURce[<n>]]:SWEep:TRIGger[:IMMediate]
[:SOURce[<n>]]:SWEep:TRIGger:SOURce
*WAI
Syntax *WAI
Description Execute any other command via the interface after all the pending operations are
completed.
Explanation This command is only applicable to the triggered sweep mode or triggered burst
mode, and is used to ensure synchronization.