Source[<n>]]:apply:triangle – RIGOL DG1000Z Series User Manual
Page 92
RIGOL
2-80
DG1000Z Programming Guide
[:SOURce[<n>]]:APPLy:TRIangle
Syntax
[:SOURce[<n>]]:APPLy:TRIangle
[<freq>|DEFault|MINimum|MAXimum[,<amp>|DEFault|MINimum|MAXimum
[,<offset>|DEFault|MINimum|MAXimum[,<phase>|DEFault|MINimum|MAXimum]]]]
Description
Set the waveform of the specified channel to triangle waveform with the specified
frequency, amplitude, offset and phase.
Parameter
Name
Type
Range
Default
[<n>]
Discrete
1|2
1
<freq>
Real
1uHz to 1MHz
1kHz
<amp>
Real
Refer to the “Explanation”
5Vpp
<offset>
Real
Refer to the “Explanation”
0V
DC
<phase>
Real
0° to 360°
0°
Explanation
The triangle waveform is ramp waveform with 100% symmetry.
When [:SOURce[<n>]] or [<n>] is omitted, the system sets the related
parameters of CH1 by default.
The range of <amp> is limited by the “Impedance” (
) and “Frequency/Period” settings. The range of
<offset> is limited by the “Impedance” and “Amplitude/High Level” settings.
Example
:SOUR1:APPL:TRI 100,1,2,3 /*Set the waveform of CH1 to triangle waveform
with 100Hz frequency, 1Vpp amplitude, 2V
DC
offset
and 3° start phase*/
Related
Commands
:OUTPut[<n>]:IMPedance
:OUTPut[<n>]:LOAD