RIGOL DG1000Z Series - Manual (Page 9)

Chapter 1 Programming Overview RIGOL
DG1000Z Programming Guide 1-3
acquire the network interface parameters available, such as the IP address, subnet mask,
default gateway and DNS service.
 Connect DG1000Z to the local network using a network cable.
 Press Utility  I/O Config  LAN to configure the IP address, subnet mask, default
gateway and DNS service.
3) Use the GPIB interface:
 Extend a GPIB interface by connecting the USB Host interface at the front panel of DG1000Z
using the USB-GPIB interface converter.
 Connect the instrument and PC using a GPIB cable.
 Press Utility  I/O Config  GPIB to set the GPIB address of the instrument.
3. Check whether the connection is successful
Start up the Ultra Sigma and the software will automatically search for the instrument resources
currently connected to the PC. Right click the resource name and select “SCPI Panel Control”. Input a
correct command in the pop-up SCPI control panel and click
and
subsequentially or directly click to check whether the connection is successful, as
shown in the figure below (the USB interface is taken as an example).