Rugged Cams Rugged Vision DVR - Manual (Page 54)

1. In SETUP, select
Mappings->Video Lost To Relay.
Procedure Using the Remote Controller
or Control Panel:
This mapping allows you to activate your
relay(s) when there is no video signal.
Video Lost to Relay
2. In Video Lost to Relay Setup, use
[UP], [DOWN], [LEFT] or [RIGHT] to navi-
gate through the menu.
3. Use [ENTER], [SELECT], [+] or
[-] to change the values. An “x” means
mapped or activated. Note that all changes
you make are always saved.
Note: You can map more than 1 camera per relay
Conversely, you can map more than 1 relay per
camera.
54