Extron electronic 3000B - Manual (Page 57)

Exatron 3000B
www.exatron.com 3-15 Chapter 3 Interface Info
RS-232 Interfaces
E XATRON S UPER ~ E XATRON RS-232 ~ H P RS-232 ~ P ROGRAMMER RS-232
RS-232 Port Options:
Listed below are addresses in the handler's battery backed-up RAM which may be edited to fine tune
the handler for your specific programmer/tester and sorting requirements. These addresses are not
part of the standard power-up selections and may be modified only by “Changing The RAM,” as
described in the Handler Set-Up Chapter of this manual.
B
AUD
R
ATE
009A __ This address stores the baud rate setting for the RS-232 serial port. The RS-232
port uses the 25 pin RS-232 connector on the side of the handler.
009A 06 19200 Baud
009A 0C 9600 Baud [Default setting]
009A 18 4800 Baud
009A 30 2400 Baud
009A 60 1200 Baud
009A C0 600 Baud
009A 80 300 Baud
D
ATA
F
ORMAT
009B __ This address stores the data format setting for the RS-232 port.
009B 02 No parity 7 Data 1 Stop
009B 2A Stick one 7 Data 1 Stop
009B 3A Stick zero 7 Data 1 Stop
009B 1A Even parity 7 Data 1 Stop
009B 0A Odd parity 7 Data 1 Stop
009B 06 No parity 7 Data 2 Stop
009B 2E Stick one 7 Data 2 Stop
009B 3E Stick zero 7 Data 2 Stop
009B 1E Even parity 7 Data 2 Stop
009B 0E Odd parity 7 Data 2 Stop
009B 03 No parity 8 Data 1 Stop [Default setting]
009B 2B Stick one 8 Data 1 Stop
009B 3B Stick zero 8 Data 1 Stop
009B 1B Even parity 8 Data 1 Stop
009B 0B Odd parity 8 Data 1 Stop
009B 07 No parity 8 Data 2 Stop
009B 2F Stick one 8 Data 2 Stop
009B 3F Stick zero 8 Data 2 Stop
009B 1F Even parity 8 Data 2 Stop
009B 0F Odd parity 8 Data 2 Stop