Interphase Tech RAS Communications Controller 5536 - Manual (Page 97)

Chapter 5: Setting Up WAN Firmware and Hardware
5536 PRI RAS Communications Controller Users Guide 77
Setting Up Card Properties
Use the Card Properties dialog box to view the board’s
hardware properties. Also, use this dialog box to enable or
disable the MVIP Bus connection (if applicable) or to change
the Serial COM ports assigned to the digital modems on the
board, if needed.
To display the Card Properties dialog box, in the Cards section
of the WAN Adapters Setup dialog box, select the 5536-DM
RAS card and click the Properties button.
The Card Properties dialog box appears:
Figure 5-2. Card Properties Dialog Box
Properties Configure a board’s hardware or port properties. You can
also use this button to access the Call Setup dialog box, as
described in
Setting Up Calls on page 89 .
Click... To do this...