Lennox Hearth G8 - Manual (Page 106)

5.12 Replacing the Azimuth Motor
1. Disconnect the motor cable from the azimuth
motor.
2. Remove the motor shield by pressing on the two
sides of the shield above the release tabs.
3. Remove the four #8-32 screws, locking nuts, and
washers securing the motor to the antenna frame.
Remove the old azimuth motor.
54-0198 108
TracVision G8 Owner’s Manual - Guide to Technical Information
Figure 5-23
Azimuth Motor Cable
#8-32 Screws
(x 4)
Figure 5-24
Azimuth Motor (Shield Removed)
Azimuth Motor
Motor Cable
Connector
Azimuth Motor
Release Tab