Lennox Hearth G8 User Manual
Page 52
Installation
54-0198
49
1. Type
HALT<cr>
to put the antenna in Idle mode.
2. Enter the
SATINSTALL
parser command as
follows:
Command:
SATINSTALL,<sat_a_name><sat_b_name><cr>
Where:
<sat_a_name> = the name of your choice for
Satellite A (for example: USER1)
<sat_b_name> = the name of your choice for
Satellite B (for example: USER2)
If you only want to install and track one satellite,
enter
NONE
as the name of Satellite B.
3. Once you’ve assigned satellites as Satellite A and
Satellite B, you need to tell the antenna which of
the two satellites it should initially acquire and
track. This step should be performed the first time
a satellite is selected, allowing the system to
download the channel guide. To do so, enter the
following parser command:
Command:
@L,x<cr>
Where:
x = A or B (whichever satellite you want to track)
4. Type
ZAP<cr>
to restart the antenna.
Examples of the user-defined satellite configuration process are
provided for reference in the next two sections.
European systems only:
If DiSEqC is active on your IRD,
once the antenna restarts, the
antenna starts tracking the satellite
currently selected by the IRD,
overriding the @L,x command.