LOREX Technology NETWORK READY H.264 HIGH PERFORMANCE DIGITAL VIDEO SURVEILLANCE RECORDER LH300 Series - Manual (Page 22)

8
Getting Started
Basic Setup
The system is designed to mount to the back of most LCD monitors with a VESA mount. If desired,
you can mount it to a wall or leave the system in a standard horizontal or vertical position.
1. Mount the System
a. Screw the provided mounting screws into the two top
holes in the rear panel of your LCD monitor. Make sure
the screws are only 3/4 of the way in; this will allow
sufficient clearance to hang the system.
b. Carefully place the system (front panel facing up) over
the screws and slide down into place.
2. Connect the Cameras
a. Connect BNC cameras to the BNC ports on the rear
panel.
3. Connect the Monitor
a. Connect the VGA / DVI cable (not included) from your LCD
monitor to the VGA or DVI port on the rear panel of the
system.
4. Connect the Ethernet cable
a. Connect the included Ethernet cable to the LAN port on
the rear panel of system; connect the other end of the
Ethernet cable to an empty LAN port on your router (not
included).
5. Connect the Flex-IR Extender
a. Connect the Flex-IR extender to the port on the rear
panel of the DVR. Position the Flex-IR extender near the
front of your monitor, or where it will receive a clear
signal from the remote control. Use a piece of
double-sided tape (included) to help secure the Flex-IR
Extender.
NOTE: The Flex-IR Extender is not required for normal operation.
It may be necessary if there is not a clear line-of-sight between the
DVR and the remote control.The Edge mini has an optional Flex IR
extender and remote control.
6. Connect the Power
a. Connect the power cord to the DC12V port in the rear
panel of the system.
ATTENTION : You can only mount the system to an LCD monitor that has a VESA mount
and an independent stand, with clear access to the VESA mount holes.
Figure 1.3 Connect the Flex IR extender
(Available as an optional accessory for the
EDGE mini)
Figure 1.1 Mount the system to the
monitor
Figure 1.2 Connect the Ethernet cable
Figure 1.0 Mounting holes on bottom panel
VESA
mount
Independe
nt stand
EDGE & EDGE
+
EDGE mini