Locate your system’s ip address and port number, Figure 24.2 system information, Viewing your system through a local area network – LOREX Technology NETWORK READY H.264 HIGH PERFORMANCE DIGITAL VIDEO SURVEILLANCE RECORDER LH300 Series User Manual
Page 70: Finding your ip address and port number
56
Setting up Local and Remote Viewing
Viewing your system through a Local Area Network
To connect to a network:
1. Power off your system by disconnecting the power cable from the rear panel.
2. Connect an Ethernet cable (included) to the LAN port on the rear panel of the system.
Connect the other end of the Ethernet cable to an empty LAN port (usually numbered 1~4) on
your router.
3. Reconnect the power cable to power the system back on.
4. Locate your system’s IP address and port number.
Finding your IP address and port number
NOTE:
Make sure you have connected the DVR to your local or wide area network via the LAN port on
the rear panel of the system.
To find your IP and MAC addresses:
1. Press the
button twice on the remote control, or front control panel (EDGE
+
only)
OR
2. From the Main Menu, click
, and then click Information. Your IP address, MAC address,
and Port number are under LAN.
3. To exit, right-click or click
"
C
"
in the menu bar until you return to the main screen.
ROUTER
(Not Included)
PC
(Not Included)
(not required for
local viewing)
INTERNET
Figure 24.1 Downloading the Safari plug-in.
Figure 24.2 System information.
System LAN information