Micromod RetroPAK: SLC Configuration Manual - Manual (Page 30)

Command Series Migration to MOD 30ML
Function Codes – Introduction
PID CONFIGURATION REFERENCE
The PID block in the MOD 30ML/Modcell is versatile and extremely powerful. We will
focus only on the parameters that we would typically use in a CLC or SLC controller.
• Open the PID block by double-clicking on it. The General tab will be displayed by
default as shown below:
Figure 1 .19.
Bailey FC Gallery
• Change the values as desired for the parameters as shown in the figure above.
• Click on the Control tab of the PID block. This tab contains configurable parameters that
are associated with the control algorithm used in the MOD 30ML/Modcell. See the
following figure:
1 - 22