LumaStream Trinity Power Cord - Manual (Page 7)

Document: 66APPMAN-PC Rev: C 22 of 28
11.3 Analog Interface Specifications
The TRINITY PC ANALOG is compatible with commercial dimming panels
and wall box dimmer products meeting IEC 60929 requirements.
The TRINITY PC ANALOG has been tested with the following 0-10 Vdc
Analog wall box dimmer products:
· HUNT PS LED series
· LEVITON DECORA IP710_DL
Additional Analog 0-10 Vdc dimmer products may also be compatible with
the TRINITY PC ANALOG. Consult LumaStream for compatibility
11.4 Analog Interface Cabling and Connections
In the end use application, proper separation between the class 2 control
wiring from the analog 0-10 Vdc interface and AC mains must be
observed in accordance with the applicable safety standards and/or
NEC/CEC requirements.
The total run length of the 0-10Vdc control wiring (purple and grey) #18
AWG should not exceed 500 feet (150 meters). In situations where the
control wiring is greater than 500 feet or electrical noise is present,
shielded twisted pair cabling should be used.
Document: 66APPMAN-PC Rev: C 7 of 28
Table 9
Analog Interface Specifications
Control Method
Analog 0-10Vdc
IEC 60929 or
ESTA E1.3-2001
Class 2 outputs
Master, Zone1 Zone2, Zone3, Zone4
outputs each source 0.5mA
maximum
Loss of Analog
Input Signal
Outputs will go to 100% light intensity in less than 1 second
Connection Method
UL recognized cage clamp connector
12 AWG to 28 AWG wiring
Electrical Isolation
Master, Zone 1, Zone 2, Zone 3, Zone 4 outputs
electrically isolated from earth ground
Table 10
TRINITY Power Cord Multi-Zone Analog Model Options
Model #
# of
Channels
Drive
Current
Output Voltage
Range (under
load Condi-
tions)
Maximum #
of LEDs per
Channel
(typical)
70-12-0350-12Z-PC 12 350 mA 12 to 47 Vdc 4 to 12
70-09-0500-12Z-PC 9 500 mA 12 to 47 Vdc 4 to 12
66-12-0700-12Z-PC 12 700 mA 6 to 27 Vdc 2 to 8
66-09-1000-12Z-PC 9 1000mA 6 to 27 Vdc 2 to 8
Table 11
Multi-Zone Analog Interface Specifications
Control Method
Analog 0-10Vdc
IEC 60929 Annex E Out-
puts 0.5mA maximum
Or
Variable 0-10Vdc Voltage
Source
Class 2 outputs
Master Control:
Simultaneous control of all
output channels
Zonal Control:
Independent control of up to 12 channels
Loss of Analog
Input Signal
Outputs will go to 100% light intensity in less than 1 second
Connection Method
UL recognized cage clamp connector
14 AWG to 28 AWG wiring
Electrical Isolation
Master, Zone 1 to Zone 12 outputs
electrically isolated from earth ground