Vanguard CT-6500 S2 - Manual (Page 43)

CT-6500 Series 2 Operating Instructions
42
9.5 Printing Timing Test Record Directory Stored in the EEPROM
The user can obtain a timing-record directory that was stored in the CT-6500’s FLASH
EEPROM by using the steps in Table 10.0.
Table 10.0 Print Timing Test Record Directory
STEP OPERATION ACTION DISPLAY
1 SELECT SETUP MENU. PRESS #3 KEY. 1.ANALYSIS POINT
2.MEASUREMENT UNITS
3.SAVE / RESTORE
4.NEXT PAGE
2 SELECT SAVE/RESTORE MENU. PRESS #3 KEY. 1.SAVE SHOT
2.RESTORE SHOT
3.SHOT DIRECTORY
4.ERASE SHOT
3 SELECT SHORT DIRECTORY. PRESS # 3 KEY. 1.SHORT DIRECTORY
2.FULL DIRECTORY
"STOP" TO QUIT
4 SELECT SHORT DIRECTORY. PRESS #1 KEY. PRINTING ABBREVIATED
DIRECTORY
“STOP” TO QUIT
5 RETURN TO MAIN MENU. NO ACTION. 1.RUN TEST 06/10/07
2.GET RESULTS 20:10:01
3.SETUP
4.DIAGNOSTIC
NOTE
1. If the "Short Directory" was selected, the CT-6500 will print out the shot
identifications of the last ten timing shots stored in the EEPROM.
2. If the "Full Directory" was selected, the CT-6500 will print out the shot
identifications of all the timing shots stored in the EEPROM.
3. A typical shot directory printout is shown on in Figure 17.0.