HP StorageWorks 2.128 SAN Director Switch - Manual (Page 241)

Fabric OS 5.x administrator guide 241
7. Enter the full path to the firmware file on the server.
For example:
8. Enter your password.
9. Answer the next prompts as indicated:
If you answer
no
in the previous example, you must manually issue the
firmwareCommit
command.
The default is
no
. If you take the default, you must later use the
haReboot
command to perform an
HA reboot manually.
NOTE: After you upgrade to Fabric OS 4.4.0 or later, the Full Install option is no longer available.
For example:
10. Wait for the firmware download to finish. (Start a new telnet session and use the
firmwareDownloadStatus
command to check the status.)
11. Issue the
haShow
command to verify that the two CP blades are synchronized.
12. If you set the option to reboot to
no
, reboot the standby CP blade.
13. Log in to the same CP blade and issue the
firmwareDownloadStatus
command to verify that the
firmware has downloaded successfully and has either committed or is in the process of doing so. (If
you set the option to perform an autocommit after reboot to no in step 9 , you must issue the
firmwareCommit
command manually.)
14. Issue the
haFailover
command to make the current CP blade active (with the updated firmware).
15. Repeat step 1 through step 13 on the other CP blade if the firmware versions are different.
/pub/v5.0.1/release.plist
Do Auto Commit after reboot [Y]: y
Reboot system after download [N]: y
switch: admin> firmwaredownload -s
Server Name or IP Address: 192.1.2.3
User Name: JohnDoe
File Name: /pub/v5.0.1/release.plist
Password: *****
Full Install (Otherwise upgrade only) [Y]: y
Do Auto Commit after reboot [Y]: y
Reboot system after download [N]: y