HP StorageWorks 2.128 SAN Director Switch - Manual (Page 246)

246
default 23
password management information 233
password migration during firmware changes 235
password prompting behaviors 234
password recovery options 236
passwords
recovering forgotten passwords 71
perfaddeemonitor command 201
perfaddIPmonitor command 205
perfaddusermonitor command 205
perfcfgrestore command 211
perfcfgsave command 211
perfdeleemonitor command 204
perfdelfiltermonitor command 206
performance monitoring commands 199
performing PID format changes 222
perfsetporteemask command 202
perfshowalpacrc command 200
perfshowporteemask command 203
persistently enabling/disabling ports 115
PID
AIX procedure 227
binding 213
PKI 52
planning the update procedure 218
policies, routing 97
port
buffer-limited 163
port and switch naming standards 116
port swapping nodes, identifying in FICON
environments 111
port-based routing 97
ports
identifying by port area ID 88
identifying by slot and port number 87
status of 132
ports, swapping 111
powering off a card 88
powering port cards on and off 88
preparing a switch 108
printing hard copies of switch information 76
privileges in accounts 22
procedural differences between fixed-port and
variable-port switches 17
public key infrastructure encryption 52
R
recognizing buffer underallocation 174
recognizing MQ-WRITE errors 151
recognizing the port initialization and FCP auto
discovery process 161
recording configuration information 118
recovering forgotten passwords 71
recovery password 69
recovery string, boot PROM password 67
registered listeners 110
related documentation 13
remote switch 231
removing
end-to-end monitors 204
filter-based monitors 206
removing members
zone 188
resolving zone conflicts 197
restoring a configuration 74
restoring a segmented fabric 148
restoring monitor configuration 211
restoring the system configuration settings 74
routing
assigning a static route 98
routing policies 97
rules for configuring zones 184
S
saved zone configuration 180
saving and restoring monitor configurations 211
saving monitor configuration 211
scope and references 17
secure shell (ssh) 40
security 40
security and zoning 197
selecting a PID format 215
serial connection 21
setting a mask for end-to-end monitors 202
setting a unique domain id 109
setting chassis configurations 90
setting mask for end-to-end monitors 202
setting mode register bits 114
setting port speeds 171
setting the boot prom password 67
setting the card beacon mode 95
setting the date and time 24
setting the default account passwords 22
setting the IP address 22
setting the security level 59
setting the switch date and time 24
setting up automatic trace dump transfers 140
setting up RADIUS AAA service 45
setup summary 112
slotshow command 34
SNMP 58 , 59 , 63 , 64 , 65
SNMPv1 61 , 62
SNMPv3 60
specifying frame order delivery 98
specifying the routing policy 97
splitting a fabric 197
standard filter-based monitors 205
standard trunking criteria 168
static PID mapping errors 214
static route 98
storage-based zoning 178
Subscriber’s choice, HP 15
summary of PID formats 213
summary of SSL procedures 53
supportsave command 140
swapping port area IDs 227
swapping ports 111
switch