HP VMA-series Memory Arrays - Manual (Page 153)

AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide 153
no arp <IP address>
Remove a static entry from the ARP cache. Note that this cannot be used to remove
dynamic entries; use clear arp-cache for that.
clear arp-cache
Clear dynamic entries in the ARP cache. Note that this does not delete static ARP
entries configured with the arp ... command.
show arp
Display the contents of the ARP cache. This should contain all of the statically-
configured ARP entries, as well as any that the system has picked up at
dynamically.
show arp static
Display a list of all statically-configured ARP entries.
Authentication Method and Order
aaa authentication login default <list of authentication
methods> ...
no aaa authentication login
Sets the list of acceptable authentication methods for system logins. local ,
radius , and tacacs+ are acceptable methods. The order in which the methods
are specified is the order in which the authentication is attempted.
aaa authorization map default-user <user name>
no aaa authorization map default-user
When a user is authenticated (via RADIUS or TACACS+) and does not have a
local account, this command specifies what local account the authenticated user
will be logged on as. If the user name is local, this mapping is ignored. This
mapping is used depending on the setting of the authorization map orde r.
aaa authorization map order {remote-only, remote-first,
local-only}
no aaa authorization map order
Can be set to one of three choices: remote-first , remote-only , or l ocal-
onl y. Used when authenticating users via RADIUS or TACACS+. The order