HP VMA-series Memory Arrays - Manual (Page 75)

AM456-9007B Rev 02 HP VMA SAN Gateway Installation and User Guide 75
2. To add additional initiators to an initiator group, use the igroup addto
command.
You can also add two Fibre Channel initiators to the same initiator group. .
Fibre Channel initiator identifiers (WWN) are fixed by the HBA port. If you
want to restrict LUN access to a particular Fibre Channel initiator, you must
get the appropriate the WWN from the Fibre Channel HBAs on the client
machine.
3. To confirm that initiators were added to the initiator group, return to the CLI
and run the show igroups command.
The show igroups command shows all initiator groups, the number of
initiators within each group, and the WWN of those initiators.
igroup create Command
The igroup create command creates an initiator group and, optionally, one or
more Fibre Channel initiators. Fibre Channel initiator identifiers (WWNs) are
generated automatically by an HBA.
Syntax
[no] igroup create name <name> initiators [initiator_name ..]
(config) # igroup addto name <igroup name> initiators
wwn.21:01:00:1b:32:ba:18:65
(config) # igroup addto name <igroup name> initiators
wwn.21:00:00:1b:32:9a:18:65 wwn.21:01:00:1b:32:ba:18:65
(config) # exit
# show igroups
Initiator group: <igroup name> #Initiators: 4
iqn.2004-02.com.vmem:initiator1
iqn.2004-02.com.vmem:initiator2
wwn.21:00:00:1b:32:9a:18:65
wwn.21:01:00:1b:32:ba:18:65