Event notification – HP VMA-series Memory Arrays User Manual
Page 131
AM456-9007B Rev 02
HP VMA SAN Gateway Installation and User Guide
131
Disable or re-enable an NTP server or peer. Servers and peers start enabled;
disabling is just a way of making them temporarily inactive without losing their
configuration.
[no] ntp enable
[no] ntp disable
Enable or disable NTP overall. Note that the latter is the Cisco command; the
former is just a pair of aliases added to increase usability, as otherwise it may be
hard for a user to figure out how to enable NTP if they are not aware of
no
commands and only see a way to disable it.
show ntp
Display current NTP settings.
Event Notification
[no] email enable
Enable or disable the sending of e-mail when certain events occur. These events are
the same as those for which SNMP traps can be sent (see
email mailhub <hostname>
no email mailhub
Set or clear the mail relay to use to send notification emails.
email mailhub-port <TCP port>
no email mailhub-port
Set the mail relay port to use to send notification emails. The
no
variant resets the
port to its default, which is 25.
email domain <domain name>
no email domain
Set the domain name to be used as the source for e-mail notifications. The specified
domain name is used in conjunction with the system hostname to form the source
e-mail address.
The rules are as follows: