HP ESL E-series Tape Libraries - Manual (Page 113)

D Sense data values
This appendix lists sense data values and descriptions. These values appear in library error codes, as
well as in the library error log.
Table 21 lists message information that can be sent from the tape library to the host computer. The
table is sorted by the data in the sense key column and lists the following information:
• Sense Key
• Additional Sense Code (ASC)
• Additional Sense Code Qualifier (ASCQ)
• Message name, description, and (potential) recovery action
• Valid Interfaces
SCSI (host computer) DIAG (diagnostic port/computer) Both = SCSI and DIAG port
Table 22 lists message information for hardware failures ASCQ values. The table is sorted by the
ASCQ column and lists the following information:
• ASCQ
• Message name, description and (potential) recovery action
Message name and description may contain abbreviations as follows:
• LU = Logical Unit
• REQ’D = Required
• DEV = Device
• DIAG = Diagnostics
• NVRAM = Nonvolatile RAM
• A/D = Analog-to-Digital
Table 21 Sense data values (hexadecimal)
Sense
key
ASC ASCQ Message name / description
0 00 00
NO ADDITIONAL SENSE INFORMATION
No recovery necessary.
2 04 00
LU IS NOT READY, CAUSE NOT REPORTABLE
Internal error. Retry command.
2 04 01
LOGICAL UNIT IN PROCESS OF BECOMING READY
Wait for library unit to complete initialization.
2 04 02
LOGICAL UNIT INIT REQUIRED
Element status or calibration unknown.
• Run the Calibrate Cabinet Test from the OCP Diagnostics menu.
• Inventory the cabinet.
2 04 03
LU IS NOT READY, MANUAL INTERVENTION REQ’D
Initialization failed. Determine failure type by checking any previous
error code returned to host. Reinitialize element status through backup
package or command line interface.
2 80 00
DOOR IS OPENED INVENTORY MAY HAVE BEEN CORRUPTED
Close door and retry command. If the system is on-line, it executes its
initialization procedure.
HP StorageWorks 113